Difference between revisions of "Polysaccharide Lyase Family 7"

Revision as of 04:25, 17 June 2020

This page has been approved by the Responsible Curator as essentially complete. CAZypedia is a living document, so further improvement of this page is still possible. If you would like to suggest an addition or correction, please contact the page's Responsible Curator directly by e-mail.

Authors: ^^^Nadine Gerlach^^^
Responsible Curator: ^^^Jan-Hendrik Hehemann^^^

Polysaccharide Lyase Family PL7
3D Structure	β jelly roll
Mechanism	β-elimination
Active site residues	R, Q, H, 2xY
CAZy DB link
https://www.cazy.org/PL7.html

Mechanism

Figure 1. Multiple protein sequence alignment of Aly PL7 as well as a secondary structure prediction with the crystallized PL7 from Klabsiella pneumoniae (PDB ID 4OZX). Conserved residues in the homologues are colored in red and (putative) catalytic residues are indicated by a star. The multiple protein sequence alignment was done with Espript3.0 [].

Alginate lyases (Alys) of all families, PL5-7, PL14-15, PL17-18, catalyze the depolymerization of alginate in three steps: (I) removal of the negative charge on the carboxylate anion, (II) general base-catalyzed abstraction of the proton on the C5 and (III) β-elimination of the 4-O-glycosidic bond [2]. Most PL7s are endo-active, i.e. acting within a poly- or oligosaccharide and releasing smaller alginate fragments. Some PL7 are exo-acting cleaving a monosaccharide from the non-reducing end of the polymer [3]. In both modes of action, a new non-reducing end with a 4-deoxy-L-erythro-hex-4-en pyranosyl uronate residue (Δ) is formed.

Some marine PL7 alginate lyases require a calcium cation for substrate recognition and binding [3]. Ca²⁺ is weakening the ionic interactions between substrate (polyanion) and PL7 (polycation) by reducing the surface density of the alginate, charge and therefore increasing the enzyme activity [4]. However, there have also been reports where mono- or divalent (metal) cations did not increase or even decreased enzymatic activity [5, 6]. Therefore, it is not clear if Ca²⁺ is required for recognition and / or binding. However, one could speculate if cations like Ca²⁺ are creating a more accessible form of alginate. In the presence of divalent cations, the confirmation of alginate is changed due to cross linkages with guluronate residues from opposing chains forming a so-called egg box model [7]. Thereby, the 3D confirmation of alginate is changed, forming hydrogels which might be an easier target in the marine environment as its dissolved form.

Kinetics and catalytic residues

Several structural and biochemical analyses of wild type and mutated PL7s revealed five residues forming the active site: arginine (R), glutamine (Q), histidine (H), tyrosine (Y) [8, 9, 10], which are present in three highly conserved regions: R*ELR*ML, VIIGQ(I/V)H, YFKAG*Y*Q respectively (Figure 1) [11]. It has been proposed that in PL7 ALY-1 from Corynebacterium sp. Q117+Y195 interact near the reaction site of alginate to maintain proper orientation of the substrate, R72 interacts with alginate due to the formation of salt bridges with the carboxyl groups at the C5 and H119 acts as a base to deprotonate [12]. However, there can also be additional charged residues at the active site, which promote substrate recognition and binding [3]. Such residues can be found in the N-terminal R*ELREML and VIIGQIH regions. Both highly conserved regions are mainly characterized by hydrophobic amino acids (especially aromatic amino acids) such as leucine, tryptophan and methionine as well as residues with planar polar side chains (especially amino acids with charged side chains) such as arginine, glutamic acid, glutamine (Figure 2). These residues have been suggested to be substrate-binding molecules [11].

Substrate specificities

Figure 2. Subfamilies of PL7s []. Unrooted tree with bootstrap values after maximum likelihood analysis. Number refer to Uniprot accession numbers. Red dots indicate enzymes from Z. galactanivorans. Pink triangles indicate enzymes characterized biochemically. Blue squares indicate that the structure of the protein has been solved.

Polysaccharide lyase family 7 (PL7) contains five subfamilies (SF) based on their sequence similarities [13], plus a so far uncharacterized sixth subfamily, which consist only of marine representatives of the Flavobacteriaceae (Figure 2) [3]. The substrate specificity depends on the source of alginate, i.e. derived from brown seaweed or mucoid bacteria Pseudomonas spp. and Azotobacter vinelandii, as well as geographical and seasonal parameters. Alginate is a heteropolysaccharide, consisting of β-D-mannuronate (M) and α-L-guluronate (G). These monosaccharides can occur in homogenous and heterogenous blocks. In addition, bacterial alginate is often acetylated at the C2 and / or C3 of mannuronate, thereby shielding the substrate from degradation. Hence, PL7s can be mannuronate (EC 4.2.2.3), guluronate (EC 4.2.2.11) or mixed link (EC 4.2.2.-) specific lyases. Despite the preference for M- or G-enriched blocks, most PL7 also have a low to moderate activity for the other building block [3, 6, 14]. PolyG specific PL7 have been found in the SF3 and SF5 [3] with QIH in the second highly conserved region, while polyM specific PL7s are characterized by QVH [15, 16].

Three-dimensional structures

Figure 3. 3D Structure of endo- and exo-active PL7s []. (A,B) endo AlyA1 and (C, D) exo AlyA5 from Zobellia galaactinovorans DsijT shown as cartoon (A,C) and surface structure (B,D) with superimposed tetrasaccharide from PDB ID 2ZAA. The image was conducted in PyMOL [].

PL7 displays a jelly roll fold, which is also found in PL14 as well as in glycoside hydrolases of family GH16. Zobellia galactanivorans DsijT possess, among others, two PL7 with different modes of activity [3]. AlyA1 is an endo-acting PL7 belonging to SF3 with a wide open cleft harboring the active site (Figure 3A, B), whereas AlyA5 belongs to SF5 and is exo-active which active site is closed by three loops forming a small pocket (Figure 3C, D). The highly conserved 9-amino-acid-block YFKAGVY*Q (where * is a variable residue) at the C-terminus of PL7s (Figure 2) has also been found for an extracellular pectate lyase (PL1, PDB: 1AIR) in E. chrysanthemi. Alginate and pectate/pectin lyases share the β-elimination mechanism, the recognition of substrates of a similar structure, Ca²⁺-binding site and primary sequence similarity, indicating that they probably possess a similar core structural fold probably important to maintain a stable 3D-confirmation [11]. Several alginate lyases have been reported to be multimodular enzymes with putative non-catalytic, carbohydrate-binding modules (CBMs). The first biochemically characterized CBM of an endo PL7 was a N-terminal CBM13 from Agarivorans sp. L11, which increased its substrate binding and therefore catalytic efficiency, influenced substrate specificity, the product profile and thermo stability [18]. Opposite observations regarding catalytic efficiency and substrate specificity were made for an endo PL7 from Vibrio splendidus OU02 DNA with an N-terminal CBM32 linked by a unique alpha-helix linker. The CBM and linker were proposed to serve as a "pivot point" somehow just pushing the product profile towards trisaccharides [19]. The PL7 from Persicobacter sp. CCB-QB2 consists of three domains - a N-terminal CBM16 with unknown function, a CBM32 and the C-terminal PL7 [14]. Overall the role of CBMs from different families as part of PL7s still remains unclear. Another common structural feature found in PLs are flexible loops facing above the active site [20], which have been demonstrated to influence substrate recognition, binding [3, 21] and potentially specificity [22].

Gene transfer of Alys among different habitats

Alginate degrading organisms often posse specified gene clusters for glycan utilization which contain, among other proteins such as transporters, several endo- and exo-acting Alys of different families. These gene clusters are called polysaccharide utilization loci (PULs) for Bacteriodetes [23] or alginolytic operons in case a SusCD pair transporter is missing or replaced by a different transporter system. It has been shown that these gene clusters can be transferred horizontally from one organism to another and thereby even cross different environmental habitats [24, 25]. The first alginate utilization system (AUS) was found in Zobellia galactinovorans which contains two clusters harboring five out of seven Alys (3x PL7). Those operons originated from an ancestral marine Flavobacterium and were independently transferred to marine Proteobacteria and Japanese gut Bacteriodetes by lateral gene transfer (LGT) [26].

A more detailed studied on horizontal gene transfer of PL7 between marine, ecophysiological different Vibrionaceae isolates revealed rapid adaptation of closely related but speciated bacterial populations, resulting into a fine scale of resource partitioning. The exchange of PL7 between marine microbes drove the evolution of polysaccharide degrading pathways, which might have led to three ecotypes – the pioneers, which degrade the polymer into oligomers, the harvester (intermediate of the other two types) and the scavenger, which can only utilize very small oligos created by the pioneers [27].

Family Firsts

First catalytic endo-activity: polyM PL7 from Photobacterium ATCC 433367 [28], polyG PL7 from Klebsiella pneumoniae subbsp. aerogenes [29]
First catalytic exo-activity: AlyA5 from Zobellia galactanivorans DsijT [3]
First 3-D apo-structure: PA1167 from Pseudomonas aeruginosa [30]
First 3-D holo-structure: A1-II from Sphingomons sp. A1 [31]
First characterised CBM: AlyL2 containing a N-terminal CBM13 from Agarivorans sp. L11 [18]

References

All Medline abstracts: PubMed

@@ Line 1: / Line 1: @@
 <!-- RESPONSIBLE CURATORS: Please replace the {{UnderConstruction}} tag below with {{CuratorApproved}} when the page is ready for wider public consumption -->
-{{UnderConstruction}}
+{{CuratorApproved}}
 * [[Author]]s: ^^^Nadine Gerlach^^^
 * [[Responsible Curator]]:  ^^^Jan-Hendrik Hehemann^^^